Fiber distributed data interface

In computer networking, Fiber distributed data interface (FDDI) ia a 100 Mbit/s ANSI standard local area network architecture, defined in X3T9.5. The underlying medium is optical fibre (though it can be copper cable, in which case it may be called CDDI) and the topology is a dual-attached, counter-rotating token ring.

FDDI rings are normally constructed in the form of a "dual ring of trees". A small number of devices, typically infrastructure devices such as routers and concentrators rather than host computers, are connected to both rings - these are referred to as "dual-attached". Host computers are then connected as single-attached devices to the routers or concentrators. The dual ring in its most degenerate form is simply collapsed into a single device. The whole dual ring is typically contained within a computer room although FDDI was also deployed as a Metropolitan area network as well.

This network topology is required because the dual ring actually passes through each connected device and requires each such device to remain continuously operational (the standard actually allows for optical bypasses but these are considered to be unreliable and error-prone). Devices such as workstations and minicomputers that may not be under the control of the network managers are not suitable for connection to the dual ring.

As an alternative to a dual-attached connection, the same degree of resilience[?] is available to a workstation through a dual-homed connection which is made simultaneously to two separate devices in the same FDDI ring. One of the connections becomes active while the other one is automatically blocked. If the first connection fails, the backup link takes over with no perceptible delay.

FDDI has been largley made redundant by Fast ethernet and more recently Gigabit ethernet due to its speed, cost and ubiquity.

The four standards are:

• ANSI X3T9.5, containing Physical Media Dependent (PMD) specifications
• ANSI X3T9.5, containing the Physical (PHY) specifications
• ANSI X3.139, containing Media Access Control (MAC) specifications
• ANSI X39.5, containing the Station Management (SMT) specifications.

The data rate of an FDDI ring may be doubled to 200 Mb/s, with loss of redundancy.

FDDI-2, a second-generation FDDI network, also supports voice and video.

Source: from Federal Standard 1037C and used with permission from http://www.Foldoc.org